Chocolate brown… even has some shine to it. Too bad this isn’t edible. You can use this rich chocolate brown to print a bear, an emoji, or perhaps a hair clip. SnoLabs PLA comes on plastic 1kg spools. SnoLabs prints very well, the overhangs are some of the best I’ve seen on PLA.

SnoLabs provided a sample roll to help this site grow.

https://snolabs.com/brown-1-75-pla/

Recommended Print Settings

Temperatures

  • Hot End - 210 Celsius
  • Bed - 60 Celsius

Speeds

  • Print Speed - 50mm/s
  • First Layer Speed - 30mm/s
  • Perimeter Speed - 30mm/s
  • Infill Speed - 60mm/s
  • Cooling Fan Speed - 100%

Structure

  • Perimeters - 2 or 0.8mm - 1mm
  • Top and Bottom Layers - 4 to 5 or 1mm
  • Infill - 15%

Retraction

  • Distance - 0.8mm*
  • Speed - 35mm*
  • Z-Lift - 0.6mm

Bridging

  • Bridge Flow - 85%
  • Bridge Speed - 30mm/s
  • Bridge Cooling - 100%

Physical

  • Bed Adhesion - Glue Stick
  • Nozzle Type - Brass (Standard)
  • Enclosure - None
* Values will differ for printers with Bowden extruders
Tagged ,

Leave a Reply

Your email address will not be published. Required fields are marked *